Signal Injector Component

VIDEO TUTORIAL: Signal Injector is covered in the video tutorial of Basic Tests and Measurement.

The Signal Injector enables you to take an audio signal of your choice and "inject" it at a Component's audio input or output. If you inject the signal at an output, it is essentially going to the input to which the output is connected.

The Signal Injector has one audio Input, and no standard outputs. Its output is the Injector.

Controls

Control	Function	Default / Range
Valid	Lights when the Injector is connected to a valid connection point.	Off/On
Injector	Injects the signal, connected to the Signal Injector Input, at the point where you connect it. The Injector effectively blocks any standard input connected to that point. In the Signal Injector Control Panel, click the Injector one time, then move it to the connector to which you want to connect it and click that connector. The Injector is attached to that connector. To remove or move it, simply click the Injector and click in a blank area of the Schematic, or in the Signal Injector Control Panel, or a different connector.	N/A
Mute	Mutes the output signal of the Injector.	Off/On
Gain (dB)	Sets the output Gain of the Injector.	Default = 0 Range = -100 to 20

Properties

There are no Properties for the Signal Injector.

Control Pins

Pin Name	Value	String	Position	Pins Available
Gain	-100 to 20	-100 dB to 20 dB	0.000 to 1.00	Input / Output
Mute	0 1	unmute mute	0 1	Input / Output
Valid	0 1	false true	0 1	Output

Pin Name

Value

String

Position

Pins Available

Gain

-100 to 20

-100 dB to 20 dB

0.000 to 1.00

Input / Output

Mute

unmute

mute

Input / Output

Valid

false

true

Output